Home » TECHNOLOGY » Wind resource estimation » Forecasting » Overview of the method

Overview of the method

There are several groups (see for example Landberg et al (2003), Martf (2000), Moehrlen (2000)) working in this area and they all have slightly different approaches.  However, in all cases, the creation of power output forecasts is a two-stage process.  First, there is the creation of site-specific meteorological forecasts (for some pre-defined reference point, such as a site met mast).  These meteorological forecasts are then transformed, via site-specific power models, to power output forecasts.  This process is shown schematically in Figure 2.13. 


Figure 2.13: Method overview, Source Garrad Hassan

Figure 2.13: Method overview, Source Garrad Hassan

Note 1: NWP is Numerical Weather Prediction and SCADA is Supervisory Control and Data Acquisition

To enable the meteorological model to be both auto-regressive and adaptive, feedback data from the site is also required.  In other words, the method needs to know what is happening at the site where predictions are being made, as well as using the forecast.  If it does so, it can ‘learn’ and also can adjust the forecasts, depending on the degree of success.  

<< Forecasting Example time series power prediction results >>
  Sitemap | Partners | Disclaimer | Contact

coordinated by


supported by

Intelligent Energy Europ

The sole responsibility for the content of this webpage lies with the authors. It does not necessarily reflect the opinion of the European Communities. The European Commission is not responsible for any use that maybe made of the information contained therein.